thead_admin 43db9e00d5 Linux_SDK_V0.9.5 1 year ago
..
Kconfig 43db9e00d5 Linux_SDK_V0.9.5 1 year ago
MAINTAINERS 43db9e00d5 Linux_SDK_V0.9.5 1 year ago
Makefile 43db9e00d5 Linux_SDK_V0.9.5 1 year ago
README 43db9e00d5 Linux_SDK_V0.9.5 1 year ago
spl.c 43db9e00d5 Linux_SDK_V0.9.5 1 year ago
wandboard.c 43db9e00d5 Linux_SDK_V0.9.5 1 year ago

README

U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 quad plus, mx6 dual lite and mx6 solo.

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-Boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard:

$ make wandboard_config
$ make

Flashing U-Boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'SPL' binary must be
flashed into the SD card;

$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

(Note - the SD card node may vary, so adjust this as needed).

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-Boot messages will appear in the serial console.