Fabio Estevam aeee33d6e0 MAINTAINERS: Use my personal e-mail address vor 3 Jahren
..
Kconfig f20562e4c4 mx6: remove SYS_SOC from board Kconfig vor 8 Jahren
MAINTAINERS aeee33d6e0 MAINTAINERS: Use my personal e-mail address vor 3 Jahren
Makefile 5ef237ad6f wandboard: Rework Makefile to prevent spl.o from being built vor 5 Jahren
README a1f79c2170 arm: wandboard: move CONFIG_MXC_UART to defconfig vor 3 Jahren
spl.c b75d8dc564 treewide: convert bd_t to struct bd_info by coccinelle vor 3 Jahren
wandboard.c 2147a16983 dm: i2c: use CONFIG_IS_ENABLED macro for DM_I2C/DM_I2C_GPIO vor 3 Jahren

README

U-Boot for Wandboard
--------------------

This file contains information for the port of U-Boot to the Wandboard.

Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 quad plus, mx6 dual lite and mx6 solo.

For more details about Wandboard, please refer to:
http://www.wandboard.org/

Building U-Boot for Wandboard
-----------------------------

To build U-Boot for the Wandboard:

$ make wandboard_config
$ make

Flashing U-Boot into the SD card
--------------------------------

- After the 'make' command completes, the generated 'SPL' binary must be
flashed into the SD card;

$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

(Note - the SD card node may vary, so adjust this as needed).

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)

- Connect the serial cable to the host PC

- Power up the board and U-Boot messages will appear in the serial console.

Debug UART
----------

The following settings provide a debug UART for the Wandboard:

CONFIG_DEBUG_UART=y
CONFIG_DEBUG_UART_MXC=y
CONFIG_DEBUG_UART_BASE=0x02020000
CONFIG_DEBUG_UART_CLOCK=80000000