David Bauer b821e0db46 rockchip: rk3328: Add support for FriendlyARM NanoPi R2S 3 лет назад
..
Kconfig 625ec503cb rockchip: rk3328: add evb-rk3328 support 7 лет назад
MAINTAINERS b821e0db46 rockchip: rk3328: Add support for FriendlyARM NanoPi R2S 3 лет назад
Makefile 625ec503cb rockchip: rk3328: add evb-rk3328 support 7 лет назад
README 625ec503cb rockchip: rk3328: add evb-rk3328 support 7 лет назад
evb-rk3328.c 38ed26777f rockchip: rk3328: Migrate to use common board file 4 лет назад

README

Introduction
============

RK3328 key features we might use in U-Boot:
* CPU: ARMv8 64bit quad-core Cortex-A53
* IRAM: 36KB
* DRAM: 4GB-16MB dual-channel
* eMMC: support eMMC 5.0/5.1, suport HS400, HS200, DDR50
* SD/MMC: support SD 3.0, MMC 4.51
* USB: USB2.0 EHCI host port *2
* Display: RGB/HDMI/DP/MIPI/EDP

evb key features:
* regulator: pwm regulator for CPU B/L
* PMIC: rk808
* debug console: UART2

In order to support Arm Trust Firmware(ATF), we need to use the
miniloader from rockchip which:
* do DRAM init
* load and verify ATF image
* load and verify U-Boot image

Here is the step-by-step to boot to U-Boot on rk3328.

Get the Source and prebuild binary
==================================

> mkdir ~/evb_rk3328
> cd ~/evb_rk3328
> git clone https://github.com/ARM-software/arm-trusted-firmware.git
> git clone https://github.com/rockchip-linux/rkbin
> git clone https://github.com/rockchip-linux/rkflashtool

Compile ATF
===============

> cd arm-trusted-firmware
> make realclean
> make CROSS_COMPILE=aarch64-linux-gnu- PLAT=rk3328 bl31

Compile U-Boot
==================

> cd ../u-boot
> make CROSS_COMPILE=aarch64-linux-gnu- evb-rk3328_defconfig all

Compile rkflashtool
=======================

> cd ../rkflashtool
> make

Package image for miniloader
================================
> cd ..
> cp arm-trusted-firmware/build/rk3328/release/bl31.bin rkbin/rk33
> ./rkbin/tools/trust_merger rkbin/tools/RK3328TRUST.ini
> ./rkbin/tools/loaderimage --pack --uboot u-boot/u-boot-dtb.bin uboot.img
> mkdir image
> mv trust.img ./image/
> mv uboot.img ./image/rk3328evb-uboot.bin

Flash image
===============
Power on(or reset with RESET KEY) with MASKROM KEY preesed, and then:

> ./rkflashtool/rkflashloader rk3328evb

You should be able to get U-Boot log message in console/UART2 now.