No Description

Marcos Kirsch b0cbe2a77f Fix for Lua builds without floating point. 9 years ago
http a8d408f375 Some example HTML file. 9 years ago
LICENSE 49d8dc8d43 Initial commit 9 years ago
README-old.md f52e8f47e6 Add all files to source control even though they are messy and don't do much yet 9 years ago
README.md 294b781a52 Updates 9 years ago
TablePrinter.lua 3e452992c8 Renamed file and minor cleanup. 9 years ago
b64.lua b0cbe2a77f Fix for Lua builds without floating point. 9 years ago
b64.py f52e8f47e6 Add all files to source control even though they are messy and don't do much yet 9 years ago
escape.py f52e8f47e6 Add all files to source control even though they are messy and don't do much yet 9 years ago
garage.lua f52e8f47e6 Add all files to source control even though they are messy and don't do much yet 9 years ago
httpserver.lua 3d4e4ee501 First pass of server. Not fully operational. Basic GET works, serves requested file. But server runs out of memory or/and only works with one connection. 9 years ago
init.lua a86b6711bb Cleaned up 9 years ago
test.lua d137648706 More of a scratch pad, shouldn't be in source control at all but oh well... 9 years ago

README-old.md

GARAGE

This project uses an ESP2866 with nodeMCU firmware to control a garage door.

Controlling a garage door from a microcontroller is easy. All you need to do is emulate a push button with a relay and wire it in parallel with the real push button on your garage door motor.

Hardware

I bought a kit from eBay that came with most of what I needed:

  • A cheap CH430 USB to Serial TTL adapter with 3.3V logic
  • A bunch of female to female jumper wires and jumpers
  • A somewhat useful carrying board that makes access to GPIO pins impossible as soldered.
  • AM1117 5V to 3.3V power supply with 800 mA capacity.
  • Female USB cable
  • ESP-01 board, which gives access to 2 GPIO pins.

Separately, I bought 2 relays that can handle way more voltage and current than I need, but are handy because I can drive them with 3.3V logic of the ESP2866.

Open issues

  • When the ESP2866 powers up, both GPIO pins are in input mode, which the relay reads as logic high. That’s not good, as it would trigger a garage door opening! I need to invert the logic. What’s the easiest and cheapest way to do this?