123456789101112131415161718192021222324252627282930313233343536 |
- How to use U-Boot on Freescale MX6ULL 14x14 EVK
- ----------------------------------------------
- - First make sure you have installed the dtc package (device tree compiler):
- $ sudo apt-get install device-tree-compiler
- - Build U-Boot for MX6ULL 14x14 EVK:
- $ make mrproper
- $ make mx6ull_14x14_evk_defconfig
- $ make
- This generates the u-boot-dtb.imx image in the current directory.
- - Flash the u-boot-dtb.imx image into the micro SD card:
- $ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 && sync
- - Jumper settings:
- SW601: 0 0 1 0
- Sw602: 1 0
- Where 0 means bottom position and 1 means top position (from the switch label
- numbers reference).
- Connect the USB cable between the EVK and the PC for the console.
- (The USB console connector is the one close the push buttons)
- Insert the micro SD card in the board, power it up and U-Boot messages should
- come up.
- The link for the board: http://www.nxp.com/products/microcontrollers-and- \
- processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \
- i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK
|