Arnout Vandecappelle 31be2ec220 boards: replace $HOST_DIR/usr/ with $HOST_DIR/ in scripts 6 年之前
..
boot.cmd 3f7c3c3c25 configs: add support for LinkSprite pcDuino 8 年之前
genimage.cfg bc0eab7d1d pcduino: Accommodate U-Boot environment on SD-card 7 年之前
linux-extras.config 3f7c3c3c25 configs: add support for LinkSprite pcDuino 8 年之前
post-build.sh 31be2ec220 boards: replace $HOST_DIR/usr/ with $HOST_DIR/ in scripts 6 年之前
post-image.sh 3f7c3c3c25 configs: add support for LinkSprite pcDuino 8 年之前
readme.txt 3f7c3c3c25 configs: add support for LinkSprite pcDuino 8 年之前

readme.txt

pcDuino v1 boards (http://www.linksprite.com/linksprite-pcduino)

Intro
=====

This default configuration will allow you to start experimenting
with the buildroot environment for the LinkSprite pcDuino v1 board
including its flavors pcDuino-Lite and pcDuino-Lite-WiFi. With the
current configuration it will bring-up the board and allow access
through the serial console as well as ethernet and wireless
network interfaces.

How to build it
===============

Configure Buildroot:

$ make linksprite_pcduino_defconfig

Modify configuration if needed, e.g. add more packages to target:

$ make menuconfig

Compile everything and build the SD card image:

$ make

How to write the SD card
========================

Once the build process is finished you will have an image
called "sdcard.img" in the output/images/ directory.

Copy the bootable "sdcard.img" onto an SD card with "dd":

$ sudo dd if=output/images/sdcard.img of=/dev/sdX

How to boot new image
=====================

Insert SD card and reset the board. By default pcDuino board
boots from SD card.