Nicholas Sielicki 3b7d75748b configs/galileo: add CONFIG_LBDAF=y in the kernel configuration 6 лет назад
..
rootfs_overlay 8715e18e93 board: add support for Intel Galileo Gen 2 8 лет назад
genimage.cfg 8715e18e93 board: add support for Intel Galileo Gen 2 8 лет назад
grub.cfg 8715e18e93 board: add support for Intel Galileo Gen 2 8 лет назад
linux-3.14.config 3b7d75748b configs/galileo: add CONFIG_LBDAF=y in the kernel configuration 6 лет назад
post-build.sh 8715e18e93 board: add support for Intel Galileo Gen 2 8 лет назад
post-image.sh 8715e18e93 board: add support for Intel Galileo Gen 2 8 лет назад
readme.txt 167cda0fac board: readme.txt for Intel Galileo Gen 1/2 8 лет назад

readme.txt


Intel Galileo Gen 1/2

Intro
============

These instructions apply to both the Intel Galileo Gen 1/2 development boards
based on the Intel Quark X1000.

How to build
============

Apply the defconfig for the Intel Galileo Gen 1/2

$ make galileo_defconfig

Add any additional packages required and build.

$ make

The build process will create a SD card image and place it in output/images.

$ ls -lh output/images/sdcard.img
-rw-r--r--. 1 foo foo 11M Nov 17 16:19 output/images/sdcard.img

Write the image to an mSD card, insert into the Galileo and power on.

$ dd if=output/images/sdcard.img of=/dev/mmcblk0; sync

Accessing the console
=====================

During power-on the console will become available on the Galileo's ttyS1. This
may be accessed as follows.

* Galileo Gen 1

http://clayskits.com/products/galileo-gen-1-serial-cable

A USB to RS-232 to 3.5mm Jack cable is required. Connect to the 3.5mm
Jack next to the Ethernet Header.

* Galileo Gen 2

http://www.ftdichip.com/Products/Cables/USBTTLSerial.htm

A FTDI TTL-232R-3V3 cable may be used to connect to the FTDI header
next to the Ethernet connector on the Galileo Gen 2.

The console should now be visible at 115200 baud.

$ picocom -b 115200 /dev/ttyUSB0