thead_admin 43db9e00d5 Linux_SDK_V0.9.5 1 년 전
..
Kconfig 43db9e00d5 Linux_SDK_V0.9.5 1 년 전
MAINTAINERS 43db9e00d5 Linux_SDK_V0.9.5 1 년 전
Makefile 43db9e00d5 Linux_SDK_V0.9.5 1 년 전
README 43db9e00d5 Linux_SDK_V0.9.5 1 년 전
dart_6ul.c 43db9e00d5 Linux_SDK_V0.9.5 1 년 전
spl.c 43db9e00d5 Linux_SDK_V0.9.5 1 년 전

README

How to use U-Boot on variscite DART-6UL Evaluation Kit
------------------------------------------------------

- Configure and build U-Boot for DART-6UL iMX6ULL:

$ make mrproper
$ make variscite_dart6ul_defconfig
$ make

This will generate SPL and u-boot-dtb.img images.

Boot from MMC/SD:
- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:

$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Boot mode settings:

Boot switch position: SW1 -> 0
SW2 -> 0

Boot from eMMC:
- if bootpart is not enabled by default, to enable under Linux
echo 0 >/sys/block/mmcblk1boot0/force_ro
mmc bootpart enable 1 1 /dev/mmcblk1boot0

- Flash the SPL and u-boot-dtb.img to mmcblk1boot0
$ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync

- Boot mode settings:

Boot switch position: SW1 -> 0
SW2 -> 1

- Connect the Serial cable to UART0 and the PC for the console.

- Insert the micro SD card in the board and power it up.

- U-Boot messages should come up.