Jagan Teki ce87a88b4d board: engicam: Attach i.MX6 common code 3 лет назад
..
Kconfig ce87a88b4d board: engicam: Attach i.MX6 common code 3 лет назад
MAINTAINERS 9faa43c4b5 ARM: dts: i.MX6UL: U-Boot specific dts for u-boot, dm-spl 6 лет назад
Makefile 83d290c56f SPDX: Convert all of our single license tags to Linux Kernel style 6 лет назад
README 52aaddd6f4 i.MX6: engicam: Add imx6q/imx6ul boards for existing boards 6 лет назад
imx6ul.c 83d290c56f SPDX: Convert all of our single license tags to Linux Kernel style 6 лет назад

README

Hsow to use U-Boot on Engicam GEAM6UL and Is.IoT MX6UL Starter Kit:
-------------------------------------------------------------------

$ make mrproper

- Configure U-Boot for Engicam GEAM6UL:
$ make imx6ul_geam_mmc_defconfig

- Configure U-Boot for Engicam Is.IoT MX6UL:
$ make imx6ul_isiot_mmc_defconfig

- Build U-Boot
$ make

This will generate the SPL image called SPL and the u-boot-dtb.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot-dtb.img image into the micro SD card:

sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

MMC Boot: JM3 Closed

- Connect the Serial cable between the Starter Kit and the PC for the console.
(J28 is the Linux Serial console connector)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.