Tom Rini 687175946c mx6ul_14x14_evk: Fix unused variable warning 7 years ago
..
Kconfig f20562e4c4 mx6: remove SYS_SOC from board Kconfig 8 years ago
MAINTAINERS 047cc75df6 MAINTAINERS: Update Peng Fan's email address 8 years ago
Makefile f0ff57b0b2 imx: mx6ul_14x14_evk add basic board support 9 years ago
README a187559e3d Use correct spelling of "U-Boot" 8 years ago
mx6ul_14x14_evk.c 687175946c mx6ul_14x14_evk: Fix unused variable warning 7 years ago

README

How to use U-Boot on Freescale MX6UL 14x14 EVK
-----------------------------------------------

- Build U-Boot for MX6UL 14x14 EVK:

$ make mrproper
$ make mx6ul_14x14_evk_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the micro SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

SW601: 0 0 1 0
Sw602: 1 0

where 0 means bottom position and 1 means top position (from the
switch label numbers reference).

- Connect the USB cable between the EVK and the PC for the console.
(The USB console connector is the one close the push buttons)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.