123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657 |
- menu "ClearFog configuration"
- depends on TARGET_CLEARFOG
- config TARGET_CLEARFOG_BASE
- bool "Use ClearFog Base static configuration"
- help
- Use the ClearFog Base as the static configuration instead of the
- default which uses the ClearFog Pro.
- Runtime board detection is always attempted and used if available. The
- static configuration is used as a fallback in cases where runtime
- detection is disabled, is not available in hardware, or otherwise fails.
- Only newer revisions of the ClearFog product line support runtime
- detection via additional EEPROM hardware. This option enables selecting
- the Base variant for older hardware revisions.
- config CLEARFOG_CON3_SATA
- bool "Use CON3 slot in SATA mode"
- help
- Use the CON3 port with SATA protocol instead of the default PCIe.
- The ClearFog port allows usage of either mSATA or miniPCIe
- modules, but the desired protocol must be configured at build
- time since it affects the SerDes topology layout.
- config CLEARFOG_CON2_SATA
- bool "Use CON2 slot in SATA mode"
- depends on !TARGET_CLEARFOG_BASE
- help
- Use the CON2 port with SATA protocol instead of the default PCIe.
- The ClearFog port allows usage of either mSATA or miniPCIe
- modules, but the desired protocol must be configured at build
- time since it affects the SerDes topology layout.
- config CLEARFOG_SFP_25GB
- bool "Enable 2.5 Gbps mode for SFP"
- help
- Set the SFP module connection to support 2.5 Gbps transfer speed for the
- SGMII connection (requires a supporting SFP). By default, transfer speed
- of 1.25 Gbps is used, suitable for a more common 1 Gbps SFP module.
- config ENV_SIZE
- hex "Environment Size"
- default 0x10000
- config ENV_OFFSET
- hex "Environment offset"
- default 0xF0000
- config ENV_SECT_SIZE
- hex "Environment Sector-Size"
- # Use SPI flash erase block size of 4 KiB
- default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI || MVEBU_SPL_BOOT_DEVICE_SATA
- # Use optimistic 64 KiB erase block, will vary between actual media
- default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC || MVEBU_SPL_BOOT_DEVICE_UART
- endmenu
|