Переглянути джерело

regulator: fix: enable gpio when requested

The fix in commit b7adcdd073c0 has the side-effect that the regulator
will be disabled when requesting the relevant gpio in
regulator_common_ofdata_to_platdata() and enabled in
regulator_pre_probe() when the regulator was already enabled.
This leads to a short interruption in the 3.3V power to the PCIe
slot on the firefly-rk3399 which makes an ADATA SX8000NP NVMe SSD
unhappy.

Fix this by setting the GPIOD_IS_OUT_ACTIVE flag again when the
'regulator-boot-on' property is set, but check for this property
explicitly instead of relying on the "boot_on" member of
the uclass platdata.

Signed-off-by: Mark Kettenis <kettenis@openbsd.org>
Tested-by: Patrice Chotard <patrice.chotard@st.com>
Mark Kettenis 4 роки тому
батько
коміт
e88d6979d1

+ 0 - 3
drivers/power/regulator/regulator-uclass.c

@@ -466,9 +466,6 @@ static int regulator_pre_probe(struct udevice *dev)
 	    (uc_pdata->min_uA == uc_pdata->max_uA))
 		uc_pdata->flags |= REGULATOR_FLAG_AUTOSET_UA;
 
-	if (uc_pdata->boot_on)
-		regulator_set_enable(dev, uc_pdata->boot_on);
-
 	return 0;
 }
 

+ 2 - 0
drivers/power/regulator/regulator_common.c

@@ -19,6 +19,8 @@ int regulator_common_ofdata_to_platdata(struct udevice *dev,
 
 	if (!dev_read_bool(dev, "enable-active-high"))
 		flags |= GPIOD_ACTIVE_LOW;
+	if (dev_read_bool(dev, "regulator-boot-on"))
+		flags |= GPIOD_IS_OUT_ACTIVE;
 
 	/* Get optional enable GPIO desc */
 	gpio = &dev_pdata->gpio;