Просмотр исходного кода

mx6memcal: Fix the UART ports for mx6sabresd/auto boards

mx6sabresd board uses the following pins for console:

PAD_CSI0_DAT10__UART1_TX_DATA
PAD_CSI0_DAT11__UART1_RX_DATA

,so put it in the same config option as wandboard.

mx6sabreauto board uses the following pins for console:

PAD_KEY_COL0__UART4_TX_DATA
PAD_KEY_ROW0__UART4_RX_DATA

So do not mention sabreauto board as part of the UART1_SD3_DAT6_7 option.

The config option for sabreauto can be added later when needed.

Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Fabio Estevam 6 лет назад
Родитель
Сommit
db00e921fd
1 измененных файлов с 2 добавлено и 10 удалено
  1. 2 10
      board/freescale/mx6memcal/Kconfig

+ 2 - 10
board/freescale/mx6memcal/Kconfig

@@ -45,20 +45,12 @@ choice
 		  NXP SABRELite.
 
 	config UART1_CSI0_DAT10_11
-		bool "UART1 on CSI0_DAT10/11 (Wand)"
+		bool "UART1 on CSI0_DAT10/11 (Wand, SabreSD)"
 		depends on SERIAL_CONSOLE_UART1
 		help
 		  Choose this configuration if you're using pads
 		  CSI0_DAT10 and DAT11 for a console on UART1 as
-		  is done on the i.MX6 Wand board.
-
-	config UART1_SD3_DAT6_7
-		bool "UART1 on SD3_DAT6/7 (SabreSD, SabreAuto)"
-		depends on SERIAL_CONSOLE_UART1
-		help
-		  Choose this configuration if you're using pads
-		  SD3_DAT6 and DAT7 for a console on UART1 as is
-		  done on the NXP SABRESD or SABREAUTO designs.
+		  is done on the i.MX6 Wand board and i.MX6 SabreSD.
 
 	config UART1_UART1
 		bool "UART1 on UART1 (i.MX6SL EVK, WaRP)"