Просмотр исходного кода

arm: dts: stm32mp1: use ssbl partition name for U-Boot

Continue to use the "ssbl" name for GPT partition of secondary boot
stage = U-Boot for basic boot with SPL to avoid to disturb existing user.

The "fip" partition name is only used for TFA_BOOT with FIP, it is a TF-A
BL2 requirement; it the default configuration for STMicroelectronics
boards.

Fixes: b73e8bf453f8 ("arm: stm32mp: add defconfig for trusted boot with FIP")
Signed-off-by: Patrick Delaunay <patrick.delaunay@foss.st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@foss.st.com>
Patrick Delaunay 2 лет назад
Родитель
Сommit
cf39d0c29d

+ 3 - 1
arch/arm/dts/stm32mp157a-dk1-u-boot.dtsi

@@ -21,11 +21,13 @@
 		st,stm32prog-gpios = <&gpioa 14 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
 	};
 
-#ifdef CONFIG_STM32MP15x_STM32IMAGE
+#if defined(CONFIG_STM32MP15x_STM32IMAGE) || defined(CONFIG_SPL)
 	config {
 		u-boot,mmc-env-partition = "ssbl";
 	};
+#endif
 
+#ifdef CONFIG_STM32MP15x_STM32IMAGE
 	/* only needed for boot with TF-A, witout FIP support */
 	firmware {
 		optee {

+ 3 - 1
arch/arm/dts/stm32mp157c-ed1-u-boot.dtsi

@@ -20,11 +20,13 @@
 		st,stm32prog-gpios = <&gpioa 14 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
 	};
 
-#ifdef CONFIG_STM32MP15x_STM32IMAGE
+#if defined(CONFIG_STM32MP15x_STM32IMAGE) || defined(CONFIG_SPL)
 	config {
 		u-boot,mmc-env-partition = "ssbl";
 	};
+#endif
 
+#ifdef CONFIG_STM32MP15x_STM32IMAGE
 	/* only needed for boot with TF-A, witout FIP support */
 	firmware {
 		optee {