|
@@ -7,12 +7,12 @@ $ make clearfog_defconfig
|
|
|
$ make
|
|
|
|
|
|
The resulting image including the SPL binary with the
|
|
|
-full DDR setup is "u-boot-spl.kwb".
|
|
|
+full DDR setup is "u-boot-with-spl.kwb".
|
|
|
|
|
|
Now all you need to do is copy this image on a SD card.
|
|
|
For example with this command:
|
|
|
|
|
|
-$ sudo dd if=u-boot-spl.kwb of=/dev/sdX bs=512 seek=1
|
|
|
+$ sudo dd if=u-boot-with-spl.kwb of=/dev/sdX bs=512 seek=1
|
|
|
|
|
|
Please use the correct device node for your setup instead
|
|
|
of "/dev/sdX" here!
|
|
@@ -29,7 +29,7 @@ command:
|
|
|
Install U-Boot on eMMC boot partition from Linux running on Clearfog:
|
|
|
|
|
|
echo 0 > /sys/block/mmcblk0boot0/force_ro
|
|
|
- dd if=u-boot-spl.kwb of=/dev/mmcblk0boot0
|
|
|
+ dd if=u-boot-with-spl.kwb of=/dev/mmcblk0boot0
|
|
|
|
|
|
Note that the SD card is not accessible when the Clearfog SOM has eMMC.
|
|
|
Consider initial boot from UART (see below).
|
|
@@ -66,7 +66,7 @@ Set the SW1 DIP switches to UART boot (see above).
|
|
|
|
|
|
Run the following command to initiate U-Boot download:
|
|
|
|
|
|
- ./tools/kwboot -b u-boot-spl.kwb /dev/ttyUSBX
|
|
|
+ ./tools/kwboot -b u-boot-with-spl.kwb /dev/ttyUSBX
|
|
|
|
|
|
Use the correct UART device node for /dev/ttyUSBX.
|
|
|
|