|
@@ -720,17 +720,6 @@ The following options need to be configured:
|
|
|
CONFIG_SCSI) you must configure support for at
|
|
|
least one non-MTD partition type as well.
|
|
|
|
|
|
-- IDE Reset method:
|
|
|
- CONFIG_IDE_RESET - is this is defined, IDE Reset will
|
|
|
- be performed by calling the function
|
|
|
- ide_set_reset(int reset)
|
|
|
- which has to be defined in a board specific file
|
|
|
-
|
|
|
-- ATAPI Support:
|
|
|
- CONFIG_ATAPI
|
|
|
-
|
|
|
- Set this to enable ATAPI support.
|
|
|
-
|
|
|
- LBA48 Support
|
|
|
CONFIG_LBA48
|
|
|
|
|
@@ -743,16 +732,6 @@ The following options need to be configured:
|
|
|
When enabled, makes the IDE subsystem use 64bit sector addresses.
|
|
|
Default is 32bit.
|
|
|
|
|
|
-- SCSI Support:
|
|
|
- CONFIG_SYS_SCSI_MAX_LUN [8], CONFIG_SYS_SCSI_MAX_SCSI_ID [7] and
|
|
|
- CONFIG_SYS_SCSI_MAX_DEVICE [CONFIG_SYS_SCSI_MAX_SCSI_ID *
|
|
|
- CONFIG_SYS_SCSI_MAX_LUN] can be adjusted to define the
|
|
|
- maximum numbers of LUNs, SCSI ID's and target
|
|
|
- devices.
|
|
|
-
|
|
|
- The environment variable 'scsidevs' is set to the number of
|
|
|
- SCSI devices found during the last scan.
|
|
|
-
|
|
|
- NETWORK Support (PCI):
|
|
|
CONFIG_E1000_SPI
|
|
|
Utility code for direct access to the SPI bus on Intel 8257x.
|
|
@@ -2393,14 +2372,6 @@ Low Level (hardware related) configuration options:
|
|
|
If this macro is defined, then CONFIG_SYS_CCSRBAR_PHYS will be
|
|
|
forced to a value that ensures that CCSR is not relocated.
|
|
|
|
|
|
-- CONFIG_IDE_AHB:
|
|
|
- Most IDE controllers were designed to be connected with PCI
|
|
|
- interface. Only few of them were designed for AHB interface.
|
|
|
- When software is doing ATA command and data transfer to
|
|
|
- IDE devices through IDE-AHB controller, some additional
|
|
|
- registers accessing to these kind of IDE-AHB controller
|
|
|
- is required.
|
|
|
-
|
|
|
- CONFIG_SYS_IMMR: Physical address of the Internal Memory.
|
|
|
DO NOT CHANGE unless you know exactly what you're
|
|
|
doing! (11-4) [MPC8xx systems only]
|