Quellcode durchsuchen

Merge tag 'u-boot-amlogic-20200511' of https://gitlab.denx.de/u-boot/custodians/u-boot-amlogic

- Enable USB Host for Odroid-C2 board
- Add Open-Drain/Open-Source emulation in GPIO uclass
Tom Rini vor 4 Jahren
Ursprung
Commit
1e6d9f515d

+ 8 - 0
arch/arm/dts/meson-gxbb-odroidc2-u-boot.dtsi

@@ -5,3 +5,11 @@
  */
 
 #include "meson-gx-u-boot.dtsi"
+
+&usb0 {
+	status = "disabled";
+};
+
+&usb1 {
+	hnp-srp-disable;
+};

+ 3 - 1
arch/sandbox/dts/test.dts

@@ -104,7 +104,9 @@
 			<&gpio_c 2 GPIO_OUT>,
 			<&gpio_c 3 (GPIO_IN|GPIO_PULL_UP)>,
 			<&gpio_c 4 (GPIO_IN|GPIO_PULL_DOWN)>,
-			<&gpio_c 5 GPIO_IN>;
+			<&gpio_c 5 GPIO_IN>,
+			<&gpio_c 6 (GPIO_ACTIVE_LOW|GPIO_OUT|GPIO_OPEN_DRAIN)>,
+			<&gpio_c 7 (GPIO_ACTIVE_LOW|GPIO_OUT|GPIO_OPEN_SOURCE)>;
 		int-value = <1234>;
 		uint-value = <(-1234)>;
 		int64-value = /bits/ 64 <0x1111222233334444>;

+ 7 - 0
configs/odroid-c2_defconfig

@@ -19,6 +19,7 @@ CONFIG_CMD_GPIO=y
 CONFIG_CMD_I2C=y
 # CONFIG_CMD_LOADS is not set
 CONFIG_CMD_MMC=y
+CONFIG_CMD_USB=y
 # CONFIG_CMD_SETEXPR is not set
 CONFIG_CMD_REGULATOR=y
 CONFIG_OF_CONTROL=y
@@ -32,14 +33,20 @@ CONFIG_MMC_MESON_GX=y
 CONFIG_PHY_REALTEK=y
 CONFIG_DM_ETH=y
 CONFIG_ETH_DESIGNWARE=y
+CONFIG_PHY=y
+CONFIG_MESON_GXBB_USB_PHY=y
 CONFIG_PINCTRL=y
 CONFIG_PINCTRL_MESON_GXBB=y
 CONFIG_DM_REGULATOR=y
 CONFIG_DM_REGULATOR_FIXED=y
+CONFIG_DM_REGULATOR_GPIO=y
 CONFIG_DM_RESET=y
 CONFIG_DEBUG_UART_MESON=y
 CONFIG_DEBUG_UART_ANNOUNCE=y
 CONFIG_DEBUG_UART_SKIP_INIT=y
 CONFIG_MESON_SERIAL=y
+CONFIG_USB=y
+CONFIG_DM_USB=y
+CONFIG_USB_DWC2=y
 CONFIG_OF_LIBFDT_OVERLAY=y
 CONFIG_SMBIOS_MANUFACTURER="Hardkernel Co., Ltd."

+ 15 - 0
drivers/gpio/gpio-uclass.c

@@ -526,6 +526,21 @@ int dm_gpio_set_value(const struct gpio_desc *desc, int value)
 
 	if (desc->flags & GPIOD_ACTIVE_LOW)
 		value = !value;
+
+	/*
+	 * Emulate open drain by not actively driving the line high or
+	 * Emulate open source by not actively driving the line low
+	 */
+	if ((desc->flags & GPIOD_OPEN_DRAIN && value) ||
+	    (desc->flags & GPIOD_OPEN_SOURCE && !value))
+		return gpio_get_ops(desc->dev)->direction_input(desc->dev,
+								desc->offset);
+	else if (desc->flags & GPIOD_OPEN_DRAIN ||
+		 desc->flags & GPIOD_OPEN_SOURCE)
+		return gpio_get_ops(desc->dev)->direction_output(desc->dev,
+								desc->offset,
+								value);
+
 	gpio_get_ops(desc->dev)->set_value(desc->dev, desc->offset, value);
 	return 0;
 }

+ 89 - 0
test/dm/gpio.c

@@ -112,6 +112,95 @@ static int dm_test_gpio(struct unit_test_state *uts)
 }
 DM_TEST(dm_test_gpio, DM_TESTF_SCAN_PDATA | DM_TESTF_SCAN_FDT);
 
+/* Test that GPIO open-drain/open-source emulation works correctly */
+static int dm_test_gpio_opendrain_opensource(struct unit_test_state *uts)
+{
+	struct gpio_desc desc_list[8];
+	struct udevice *dev, *gpio_c;
+	char buf[80];
+
+	ut_assertok(uclass_get_device(UCLASS_TEST_FDT, 0, &dev));
+	ut_asserteq_str("a-test", dev->name);
+
+	ut_assertok(uclass_get_device(UCLASS_GPIO, 3, &gpio_c));
+	ut_asserteq_str("pinmux-gpios", gpio_c->name);
+
+	ut_asserteq(8, gpio_request_list_by_name(dev, "test3-gpios", desc_list,
+						 ARRAY_SIZE(desc_list), 0))
+
+	ut_asserteq(true, !!device_active(gpio_c));
+	ut_asserteq_ptr(gpio_c, desc_list[0].dev);
+	ut_asserteq_ptr(gpio_c, desc_list[1].dev);
+	ut_asserteq_ptr(gpio_c, desc_list[2].dev);
+	ut_asserteq_ptr(gpio_c, desc_list[3].dev);
+	ut_asserteq_ptr(gpio_c, desc_list[4].dev);
+	ut_asserteq_ptr(gpio_c, desc_list[5].dev);
+	ut_asserteq_ptr(gpio_c, desc_list[6].dev);
+	ut_asserteq_ptr(gpio_c, desc_list[7].dev);
+
+	/* GPIO 0 is (GPIO_OUT|GPIO_OPEN_DRAIN) */
+	ut_asserteq(GPIOD_IS_OUT | GPIOD_OPEN_DRAIN,
+		    sandbox_gpio_get_dir_flags(gpio_c, 0));
+
+	/* Set it as output high, should become an input */
+	ut_assertok(dm_gpio_set_value(&desc_list[0], 1));
+	ut_assertok(gpio_get_status(gpio_c, 0, buf, sizeof(buf)));
+	ut_asserteq_str("c0: input: 0 [x] a-test.test3-gpios0", buf);
+
+	/* Set it as output low, should become output low */
+	ut_assertok(dm_gpio_set_value(&desc_list[0], 0));
+	ut_assertok(gpio_get_status(gpio_c, 0, buf, sizeof(buf)));
+	ut_asserteq_str("c0: output: 0 [x] a-test.test3-gpios0", buf);
+
+	/* GPIO 1 is (GPIO_OUT|GPIO_OPEN_SOURCE) */
+	ut_asserteq(GPIOD_IS_OUT | GPIOD_OPEN_SOURCE,
+		    sandbox_gpio_get_dir_flags(gpio_c, 1));
+
+	/* Set it as output high, should become output high */
+	ut_assertok(dm_gpio_set_value(&desc_list[1], 1));
+	ut_assertok(gpio_get_status(gpio_c, 1, buf, sizeof(buf)));
+	ut_asserteq_str("c1: output: 1 [x] a-test.test3-gpios1", buf);
+
+	/* Set it as output low, should become an input */
+	ut_assertok(dm_gpio_set_value(&desc_list[1], 0));
+	ut_assertok(gpio_get_status(gpio_c, 1, buf, sizeof(buf)));
+	ut_asserteq_str("c1: input: 1 [x] a-test.test3-gpios1", buf);
+
+	/* GPIO 6 is (GPIO_ACTIVE_LOW|GPIO_OUT|GPIO_OPEN_DRAIN) */
+	ut_asserteq(GPIOD_ACTIVE_LOW | GPIOD_IS_OUT | GPIOD_OPEN_DRAIN,
+		    sandbox_gpio_get_dir_flags(gpio_c, 6));
+
+	/* Set it as output high, should become output low */
+	ut_assertok(dm_gpio_set_value(&desc_list[6], 1));
+	ut_assertok(gpio_get_status(gpio_c, 6, buf, sizeof(buf)));
+	ut_asserteq_str("c6: output: 0 [x] a-test.test3-gpios6", buf);
+
+	/* Set it as output low, should become an input */
+	ut_assertok(dm_gpio_set_value(&desc_list[6], 0));
+	ut_assertok(gpio_get_status(gpio_c, 6, buf, sizeof(buf)));
+	ut_asserteq_str("c6: input: 0 [x] a-test.test3-gpios6", buf);
+
+	/* GPIO 7 is (GPIO_ACTIVE_LOW|GPIO_OUT|GPIO_OPEN_SOURCE) */
+	ut_asserteq(GPIOD_ACTIVE_LOW | GPIOD_IS_OUT | GPIOD_OPEN_SOURCE,
+		    sandbox_gpio_get_dir_flags(gpio_c, 7));
+
+	/* Set it as output high, should become an input */
+	ut_assertok(dm_gpio_set_value(&desc_list[7], 1));
+	ut_assertok(gpio_get_status(gpio_c, 7, buf, sizeof(buf)));
+	ut_asserteq_str("c7: input: 0 [x] a-test.test3-gpios7", buf);
+
+	/* Set it as output low, should become output high */
+	ut_assertok(dm_gpio_set_value(&desc_list[7], 0));
+	ut_assertok(gpio_get_status(gpio_c, 7, buf, sizeof(buf)));
+	ut_asserteq_str("c7: output: 1 [x] a-test.test3-gpios7", buf);
+
+	ut_assertok(gpio_free_list(dev, desc_list, 8));
+
+	return 0;
+}
+DM_TEST(dm_test_gpio_opendrain_opensource,
+	DM_TESTF_SCAN_PDATA | DM_TESTF_SCAN_FDT);
+
 /* Test that sandbox anonymous GPIOs work correctly */
 static int dm_test_gpio_anon(struct unit_test_state *uts)
 {