封欢 720f21763f initial uboot use package u-boot-2021.01.tar.gz 3 jaren geleden
..
Kconfig 720f21763f initial uboot use package u-boot-2021.01.tar.gz 3 jaren geleden
MAINTAINERS 720f21763f initial uboot use package u-boot-2021.01.tar.gz 3 jaren geleden
Makefile 720f21763f initial uboot use package u-boot-2021.01.tar.gz 3 jaren geleden
README 720f21763f initial uboot use package u-boot-2021.01.tar.gz 3 jaren geleden
pcl063.c 720f21763f initial uboot use package u-boot-2021.01.tar.gz 3 jaren geleden
spl.c 720f21763f initial uboot use package u-boot-2021.01.tar.gz 3 jaren geleden

README

How to use U-Boot on PHYTEC phyBOARD-i.MX6UL-Segin
--------------------------------------------------

- Configure and build U-Boot for phyCORE-i.MX6UL:

$ make mrproper
$ make phycore_pcl063_defconfig
$ make

This will generate SPL and u-boot-dtb.img images.

- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:

$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

JP1: Open: Boot from NAND
Closed: Boot from SD/MMC1

- Connect the Serial cable to UART0 and the PC for the console.

- Insert the micro SD card in the board and power it up.

- U-Boot messages should come up.