ソースを参照

EmbeddedPkg: MmcDxe: wait OCR busy bit free

According to eMMC spec, OCR.PowerUp bit is also busy bit. If the busy
bit is '0', CMD1 should be sent and OCR should be fetched again. And add
a timeout counter on the repeated steps.

Contributed-under: TianoCore Contribution Agreement 1.0
Signed-off-by: Haojian Zhuang <haojian.zhuang@linaro.org>
Tested-by: Ryan Harkin <ryan.harkin@linaro.org>
Reviewed-by: Leif Lindholm <leif.lindholm@linaro.org>
Haojian Zhuang 7 年 前
コミット
3201075377
1 ファイル変更8 行追加3 行削除
  1. 8 3
      EmbeddedPkg/Universal/MmcDxe/MmcIdentification.c

+ 8 - 3
EmbeddedPkg/Universal/MmcDxe/MmcIdentification.c

@@ -222,14 +222,19 @@ MmcIdentificationMode (
 
   // Send CMD1 to get OCR (MMC)
   // This command only valid for MMC and eMMC
-  Status = MmcHost->SendCommand (MmcHost, MMC_CMD1, EMMC_CMD1_CAPACITY_GREATER_THAN_2GB);
-  if (Status == EFI_SUCCESS) {
+  Timeout = MAX_RETRY_COUNT;
+  do {
+    Status = MmcHost->SendCommand (MmcHost, MMC_CMD1, EMMC_CMD1_CAPACITY_GREATER_THAN_2GB);
+    if (EFI_ERROR (Status))
+      break;
     Status = MmcHost->ReceiveResponse (MmcHost, MMC_RESPONSE_TYPE_OCR, (UINT32 *)&OcrResponse);
     if (EFI_ERROR (Status)) {
       DEBUG ((EFI_D_ERROR, "MmcIdentificationMode() : Failed to receive OCR, Status=%r.\n", Status));
       return Status;
     }
-
+    Timeout--;
+  } while (!OcrResponse.Ocr.PowerUp && (Timeout > 0));
+  if (Status == EFI_SUCCESS) {
     if (!OcrResponse.Ocr.PowerUp) {
       DEBUG ((EFI_D_ERROR, "MmcIdentificationMode(MMC_CMD1): Card initialisation failure, Status=%r.\n", Status));
       return EFI_DEVICE_ERROR;