|
@@ -941,7 +941,7 @@ UsbEnumeratePort (
|
|
|
// which probably is caused by short circuit. It has to wait system hardware
|
|
|
// to perform recovery.
|
|
|
//
|
|
|
- DEBUG ((DEBUG_ERROR, "UsbEnumeratePort: Critical Over Current\n", Port));
|
|
|
+ DEBUG ((DEBUG_ERROR, "UsbEnumeratePort: Critical Over Current (port %d)\n", Port));
|
|
|
return EFI_DEVICE_ERROR;
|
|
|
}
|
|
|
|
|
@@ -951,7 +951,7 @@ UsbEnumeratePort (
|
|
|
// over current. As a result, all ports are nearly power-off, so
|
|
|
// it's necessary to detach and enumerate all ports again.
|
|
|
//
|
|
|
- DEBUG ((DEBUG_ERROR, "UsbEnumeratePort: 2.0 device Recovery Over Current\n", Port));
|
|
|
+ DEBUG ((DEBUG_ERROR, "UsbEnumeratePort: 2.0 device Recovery Over Current (port %d)\n", Port));
|
|
|
}
|
|
|
|
|
|
if (USB_BIT_IS_SET (PortState.PortChangeStatus, USB_PORT_STAT_C_ENABLE)) {
|
|
@@ -961,7 +961,7 @@ UsbEnumeratePort (
|
|
|
// on 2.0 roothub does. When over-current has influence on 1.1 device, the port
|
|
|
// would be disabled, so it's also necessary to detach and enumerate again.
|
|
|
//
|
|
|
- DEBUG ((DEBUG_ERROR, "UsbEnumeratePort: 1.1 device Recovery Over Current\n", Port));
|
|
|
+ DEBUG ((DEBUG_ERROR, "UsbEnumeratePort: 1.1 device Recovery Over Current (port %d)\n", Port));
|
|
|
}
|
|
|
|
|
|
if (USB_BIT_IS_SET (PortState.PortChangeStatus, USB_PORT_STAT_C_CONNECTION)) {
|
|
@@ -969,7 +969,7 @@ UsbEnumeratePort (
|
|
|
// Case4:
|
|
|
// Device connected or disconnected normally.
|
|
|
//
|
|
|
- DEBUG ((DEBUG_INFO, "UsbEnumeratePort: Device Connect/Disconnect Normally\n", Port));
|
|
|
+ DEBUG ((DEBUG_INFO, "UsbEnumeratePort: Device Connect/Disconnect Normally (port %d)\n", Port));
|
|
|
}
|
|
|
|
|
|
//
|