封欢 1278ddf908 init buildroot source 3 年 前
..
genimage.cfg 1278ddf908 init buildroot source 3 年 前
readme.txt 1278ddf908 init buildroot source 3 年 前

readme.txt

********************************************
Buildroot for Engicam Is.IoT SOM platforms:
********************************************

This file documents the Buildroot support for all Engicam Is.IoT MX6UL
SOM platform boards.

Is.IoT MX6UL SOM Starter kits:
https://www.engicam.com/vis-prod/101122

This configuration uses U-Boot mainline and kernel mainline.

Build
=====

First, configure Buildroot for the Engicam Is.IoT MX6UL SOM:

- for Is.IoT MX6UL SOM:

make engicam_imx6ul_isiot_defconfig

Build all components:

make

You will find the following files in output/images/:
- imx6ul-isiot-emmc.dtb
- rootfs.ext4
- rootfs.tar
- sdcard.img
- SPL
- u-boot-dtb.img
- uImage

Create a bootable SD card
=========================

To determine the device associated to the SD card have a look in the
/proc/partitions file:

cat /proc/partitions

Buildroot prepares a bootable "sdcard.img" image in the output/images/
directory, ready to be dumped on a SD card. Launch the following
command as root:

dd if=output/images/sdcard.img of=/dev/
sync

*** WARNING! This will destroy all the card content. Use with care! ***

For details about the medium image layout, see the definition in
board/engicam/isiot/genimage.cfg

Boot the Is.IoT MX6UL boards with SD boot:
=========================================

To boot your newly created system:
- insert the SD card in the SD slot of the board;
- connect 3-wire RS232 serial port J28 on board, and connect with other
serial end or USB cable(if serial-to-usb converter used) using
a terminal emulator at 115200 bps, 8n1;
- close JM3 for sd boot.
- power on the board.

Enjoy!