123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051 |
- ********************************
- Xilinx ZCU106 board - ZynqMP SoC
- ********************************
- This document describes the Buildroot support for the ZCU106 board by
- Xilinx, based on the Zynq UltraScale+ MPSoC (aka ZynqMP). It has been
- tested with the EK-U1-ZCU106-ES2 pre-production board.
- How to build it
- ===============
- Configure Buildroot:
- $ make zynqmp_zcu106_defconfig
- Compile everything and build the rootfs image:
- $ make
- Result of the build
- -------------------
- After building, you should get a tree like this:
- output/images/
- +-- atf-uboot.ub
- +-- bl31.bin
- +-- boot.bin
- +-- boot.vfat
- +-- Image
- +-- rootfs.ext2
- +-- rootfs.ext4 -> rootfs.ext2
- +-- sdcard.img
- +-- system.dtb -> zynqmp-zcu106-revA.dtb
- +-- u-boot.bin
- `-- zynqmp-zcu106-revA.dtb
- How to write the SD card
- ========================
- WARNING! This will destroy all the card content. Use with care!
- The sdcard.img file is a complete bootable image ready to be written
- on the boot medium. To install it, simply copy the image to an SD
- card:
- # dd if=output/images/sdcard.img of=/dev/sdX
- Where 'sdX' is the device node of the SD.
- Eject the SD card, insert it in the board, and power it up.
|