123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193 |
- /**
- * @file lv_drv_conf.h
- *
- */
- #if 0 /*Remove this to enable the content*/
- #ifndef LV_DRV_CONF_H
- #define LV_DRV_CONF_H
- #include "lv_conf.h"
- /*********************
- * DELAY INTERFACE
- *********************/
- #define LV_DRV_DELAY_INCLUDE <stdint.h> /*Dummy include by default*/
- #define LV_DRV_DELAY_US(us) /*delay_us(us)*/ /*Delay the given number of microseconds*/
- #define LV_DRV_DELAY_MS(ms) /*delay_ms(ms)*/ /*Delay the given number of milliseconds*/
- /*********************
- * DISPLAY INTERFACE
- *********************/
- /*------------
- * Common
- *------------*/
- #define LV_DRV_DISP_INCLUDE <stdint.h> /*Dummy include by default*/
- #define LV_DRV_DISP_CMD_DATA(val) /*pin_x_set(val)*/ /*Set the command/data pin to 'val'*/
- #define LV_DRV_DISP_RST(val) /*pin_x_set(val)*/ /*Set the reset pin to 'val'*/
- /*---------
- * SPI
- *---------*/
- #define LV_DRV_DISP_SPI_CS(val) /*spi_cs_set(val)*/ /*Set the SPI's Chip select to 'val'*/
- #define LV_DRV_DISP_SPI_WR_BYTE(data) /*spi_wr(data)*/ /*Write a byte the SPI bus*/
- #define LV_DRV_DISP_SPI_WR_ARRAY(adr, n) /*spi_wr_mem(adr, n)*/ /*Write 'n' bytes to SPI bus from 'adr'*/
- /*------------------
- * Parallel port
- *-----------------*/
- #define LV_DRV_DISP_PAR_CS(val) /*par_cs_set(val)*/ /*Set the Parallel port's Chip select to 'val'*/
- #define LV_DRV_DISP_PAR_SLOW /*par_slow()*/ /*Set low speed on the parallel port*/
- #define LV_DRV_DISP_PAR_FAST /*par_fast()*/ /*Set high speed on the parallel port*/
- #define LV_DRV_DISP_PAR_WR_WORD(data) /*par_wr(data)*/ /*Write a word to the parallel port*/
- #define LV_DRV_DISP_PAR_WR_ARRAY(adr, n) /*par_wr_mem(adr,n)*/ /*Write 'n' bytes to Parallel ports from 'adr'*/
- /***************************
- * INPUT DEVICE INTERFACE
- ***************************/
- /*----------
- * Common
- *----------*/
- #define LV_DRV_INDEV_INCLUDE <stdint.h> /*Dummy include by default*/
- #define LV_DRV_INDEV_RST(val) /*pin_x_set(val)*/ /*Set the reset pin to 'val'*/
- #define LV_DRV_INDEV_IRQ_READ 0 /*pn_x_read()*/ /*Read the IRQ pin*/
- /*---------
- * SPI
- *---------*/
- #define LV_DRV_INDEV_SPI_CS(val) /*spi_cs_set(val)*/ /*Set the SPI's Chip select to 'val'*/
- #define LV_DRV_INDEV_SPI_XCHG_BYTE(data) 0 /*spi_xchg(val)*/ /*Write 'val' to SPI and give the read value*/
- /*---------
- * I2C
- *---------*/
- #define LV_DRV_INDEV_I2C_START /*i2c_start()*/ /*Make an I2C start*/
- #define LV_DRV_INDEV_I2C_STOP /*i2c_stop()*/ /*Make an I2C stop*/
- #define LV_DRV_INDEV_I2C_RESTART /*i2c_restart()*/ /*Make an I2C restart*/
- #define LV_DRV_INDEV_I2C_WR(data) /*i2c_wr(data)*/ /*Write a byte to the I1C bus*/
- #define LV_DRV_INDEV_I2C_READ(last_read) 0 /*i2c_rd()*/ /*Read a byte from the I2C bud*/
- /*********************
- * DISPLAY DRIVERS
- *********************/
- /*-------------------
- * Monitor of PC
- *-------------------*/
- #define USE_MONITOR 0
- #if USE_MONITOR
- #define MONITOR_HOR_RES LV_HOR_RES
- #define MONITOR_VER_RES LV_HOR_VER
- #endif
- /*----------------
- * SSD1963
- *--------------*/
- #define USE_SSD1963 0
- #if USE_SSD1963
- #define SSD1963_HOR_RES LV_HOR_RES
- #define SSD1963_VER_RES LV_VER_RES
- #define SSD1963_HDP 479
- #define SSD1963_HT 531
- #define SSD1963_HPS 43
- #define SSD1963_LPS 8
- #define SSD1963_HPW 10
- #define SSD1963_VDP 271
- #define SSD1963_VT 288
- #define SSD1963_VPS 12
- #define SSD1963_FPS 4
- #define SSD1963_VPW 10
- #define SSD1963_HS_NEG 0 /*Negative hsync*/
- #define SSD1963_VS_NEG 0 /*Negative vsync*/
- #define SSD1963_ORI 0 /*0, 90, 180, 270*/
- #define SSD1963_COLOR_DEPTH 16
- #endif
- /*----------------
- * R61581
- *--------------*/
- #define USE_R61581 1
- #if USE_R61581 != 0
- #define R61581_HOR_RES LV_HOR_RES
- #define R61581_VER_RES LV_VER_RES
- #define R61581_HSPL 0 /*HSYNC signal polarity*/
- #define R61581_HSL 10 /*HSYNC length (Not Implemented)*/
- #define R61581_HFP 10 /*Horitontal Front poarch (Not Implemented)*/
- #define R61581_HBP 10 /*Horitontal Back poarch (Not Implemented */
- #define R61581_VSPL 0 /*VSYNC signal polarity*/
- #define R61581_VSL 10 /*VSYNC length (Not Implemented)*/
- #define R61581_VFP 8 /*Vertical Front poarch*/
- #define R61581_VBP 8 /*Vertical Back poarch */
- #define R61581_DPL 0 /*DCLK signal polarity*/
- #define R61581_EPL 1 /*ENABLE signal polarity*/
- #define R61581_ORI 0 /*0, 180*/
- #define R61581_LV_COLOR_DEPTH 16 /*Fix 16 bit*/
- #endif
- /*------------------------------
- * ST7565 (Monochrome, low res.)
- *-----------------------------*/
- #define USE_ST7565 0
- #if USE_ST7565 != 0
- /*No settings*/
- #endif /*USE_ST7565*/
- /*-----------------------------------------
- * Linux frame buffer device (/dev/fbx)
- *-----------------------------------------*/
- #define USE_FBDEV 0
- #if USE_FBDEV != 0
- #define FBDEV_PATH "/dev/fb0"
- #endif
- /*====================
- * Input devices
- *===================*/
- /*--------------
- * XPT2046
- *--------------*/
- #define USE_XPT2046 0
- #if USE_XPT2046 != 0
- #define XPT2046_HOR_RES 480
- #define XPT2046_VER_RES 320
- #define XPT2046_X_MIN 200
- #define XPT2046_Y_MIN 200
- #define XPT2046_X_MAX 3800
- #define XPT2046_Y_MAX 3800
- #define XPT2046_AVG 4
- #define XPT2046_INV 0
- #endif
- /*-----------------
- * FT5406EE8
- *-----------------*/
- #define USE_FT5406EE8 0
- #if USE_FT5406EE8
- #define FT5406EE8_I2C_ADR 0x38 /*7 bit address*/
- #endif
- /*-------------------------------
- * Mouse or touchpad on PC
- *------------------------------*/
- #define USE_MOUSE 0
- #if USE_MOUSE
- /*No settings*/
- #endif
- /*-------------------------------
- * Keyboard of a PC
- *------------------------------*/
- #define USE_KEYBOARD 0
- #if USE_KEYBOARD
- /*No settings*/
- #endif
- #endif /*LV_DRV_CONF_H*/
- #endif /*Remove this to enable the content*/
|