|
@@ -1,166 +0,0 @@
|
|
|
-/* System calls. */
|
|
|
-#define SEND 1 /* function code for sending messages */
|
|
|
-#define RECEIVE 2 /* function code for receiving messages */
|
|
|
-#define BOTH 3 /* function code for SEND + RECEIVE */
|
|
|
-#define ANY (NR_PROCS+100) /* receive(ANY, buf) accepts from any source */
|
|
|
-
|
|
|
-/* Task numbers, function codes and reply codes. */
|
|
|
-
|
|
|
-#define TTY -NR_TASKS /* terminal I/O class */
|
|
|
-# define TTY_READ 3 /* fcn code for reading from tty */
|
|
|
-# define TTY_WRITE 4 /* fcn code for writing to tty */
|
|
|
-# define TTY_IOCTL 5 /* fcn code for ioctl */
|
|
|
-# define TTY_SETPGRP 6 /* fcn code for setpgrp */
|
|
|
-# define TTY_OPEN 7 /* fcn code for opening tty */
|
|
|
-# define TTY_CLOSE 8 /* fcn code for closing tty */
|
|
|
-# define SUSPEND -998 /* used in interrupts when tty has no data */
|
|
|
-
|
|
|
-#ifdef AM_KERNEL
|
|
|
-#define AMOEBA
|
|
|
-#endif
|
|
|
-
|
|
|
-#ifdef AMOEBA
|
|
|
-
|
|
|
-/* There are AM_NTASK copies of the amoeba kernel task.
|
|
|
- * If you change AM_NTASKS be sure to adjust kernel/table.c and fs/table.c
|
|
|
- */
|
|
|
-#define AM_NTASKS 4 /* number of kernel tasks of this class */
|
|
|
-
|
|
|
-#define AMINT_CLASS (TTY+1) /* Amoeba event handler */
|
|
|
-#define AMOEBA_CLASS (AMINT_CLASS+AM_NTASKS) /* transaction handlers */
|
|
|
-# define ETHER_ARRIV 1 /* fcn code for packet arrival */
|
|
|
-# define AM_TRANS 2 /* amoeba transaction */
|
|
|
-# define AM_GETREQ 3 /* amoeba getrequest */
|
|
|
-# define AM_PUTREP 4 /* amoeba putrep */
|
|
|
-# define AM_REVIVE 6 /* used by kernel task to revive luser task */
|
|
|
-# define AM_TIMEOUT 8 /* used to talk to clock task */
|
|
|
-# define AM_PUTSIG 9 /* when the luser hits the DEL ! */
|
|
|
-# define AM_TASK_DIED 10 /* sent if task died during a transaction */
|
|
|
-
|
|
|
-#else /* if AMOEBA not defined */
|
|
|
-
|
|
|
-#define AMOEBA_CLASS TTY
|
|
|
-
|
|
|
-#endif /* AMOEBA */
|
|
|
-
|
|
|
-/*
|
|
|
- * New class definitions should go here and should be defined relative
|
|
|
- * to AMOEBA_CLASS (ie. as AMOEBA_CLASS+n, for the nth task added).
|
|
|
- */
|
|
|
-
|
|
|
-#define IDLE (AMOEBA_CLASS+1) /* task to run when there's nothing to run */
|
|
|
-
|
|
|
-#define PRINTER -7 /* printer I/O class */
|
|
|
-/* The printer uses the same commands as TTY. */
|
|
|
-
|
|
|
-#define WINCHESTER -6 /* winchester (hard) disk class */
|
|
|
-#define FLOPPY -5 /* floppy disk class */
|
|
|
-# define DISK_READ 3 /* fcn code to DISK (must equal TTY_READ) */
|
|
|
-# define DISK_WRITE 4 /* fcn code to DISK (must equal TTY_WRITE) */
|
|
|
-# define DISK_IOCTL 5 /* fcn code for setting up RAM disk */
|
|
|
-# define SCATTERED_IO 6 /* fcn code for multiple reads/writes */
|
|
|
-# define OPTIONAL_IO 16 /* modifier to DISK_* codes within vector */
|
|
|
-
|
|
|
-#define MEM -4 /* /dev/ram, /dev/(k)mem and /dev/null class */
|
|
|
-# define RAM_DEV 0 /* minor device for /dev/ram */
|
|
|
-# define MEM_DEV 1 /* minor device for /dev/mem */
|
|
|
-# define KMEM_DEV 2 /* minor device for /dev/kmem */
|
|
|
-# define NULL_DEV 3 /* minor device for /dev/null */
|
|
|
-#if (CHIP == INTEL)
|
|
|
-# define PORT_DEV 4 /* minor device for /dev/port */
|
|
|
-#endif
|
|
|
-
|
|
|
-#define CLOCK -3 /* clock class */
|
|
|
-# define SET_ALARM 1 /* fcn code to CLOCK, set up alarm */
|
|
|
-# define GET_TIME 3 /* fcn code to CLOCK, get real time */
|
|
|
-# define SET_TIME 4 /* fcn code to CLOCK, set real time */
|
|
|
-# define REAL_TIME 1 /* reply from CLOCK: here is real time */
|
|
|
-
|
|
|
-#define SYSTASK -2 /* internal functions */
|
|
|
-# define SYS_XIT 1 /* fcn code for sys_xit(parent, proc) */
|
|
|
-# define SYS_GETSP 2 /* fcn code for sys_sp(proc, &new_sp) */
|
|
|
-# define SYS_SIG 3 /* fcn code for sys_sig(proc, sig) */
|
|
|
-# define SYS_FORK 4 /* fcn code for sys_fork(parent, child) */
|
|
|
-# define SYS_NEWMAP 5 /* fcn code for sys_newmap(procno, map_ptr) */
|
|
|
-# define SYS_COPY 6 /* fcn code for sys_copy(ptr) */
|
|
|
-# define SYS_EXEC 7 /* fcn code for sys_exec(procno, new_sp) */
|
|
|
-# define SYS_TIMES 8 /* fcn code for sys_times(procno, bufptr) */
|
|
|
-# define SYS_ABORT 9 /* fcn code for sys_abort() */
|
|
|
-# define SYS_FRESH 10 /* fcn code for sys_fresh() (Atari only) */
|
|
|
-# define SYS_KILL 11 /* fcn code for sys_kill(proc, sig) */
|
|
|
-# define SYS_GBOOT 12 /* fcn code for sys_gboot(procno, bootptr) */
|
|
|
-# define SYS_UMAP 13 /* fcn code for sys_umap(procno, etc) */
|
|
|
-# define SYS_MEM 14 /* fcn code for sys_mem() */
|
|
|
-# define SYS_TRACE 15 /* fcn code for sys_trace(req,pid,addr,data) */
|
|
|
-
|
|
|
-#define HARDWARE -1 /* used as source on interrupt generated msgs*/
|
|
|
-
|
|
|
-/* Names of message fields for messages to CLOCK task. */
|
|
|
-#define DELTA_TICKS m6_l1 /* alarm interval in clock ticks */
|
|
|
-#define FUNC_TO_CALL m6_f1 /* pointer to function to call */
|
|
|
-#define NEW_TIME m6_l1 /* value to set clock to (SET_TIME) */
|
|
|
-#define CLOCK_PROC_NR m6_i1 /* which proc (or task) wants the alarm? */
|
|
|
-#define SECONDS_LEFT m6_l1 /* how many seconds were remaining */
|
|
|
-
|
|
|
-/* Names of message fields used for messages to block and character tasks. */
|
|
|
-#define DEVICE m2_i1 /* major-minor device */
|
|
|
-#define PROC_NR m2_i2 /* which (proc) wants I/O? */
|
|
|
-#define COUNT m2_i3 /* how many bytes to transfer */
|
|
|
-#define POSITION m2_l1 /* file offset */
|
|
|
-#define ADDRESS m2_p1 /* core buffer address */
|
|
|
-
|
|
|
-/* Names of message fields for messages to TTY task. */
|
|
|
-#define TTY_LINE m2_i1 /* message parameter: terminal line */
|
|
|
-#define TTY_REQUEST m2_i3 /* message parameter: ioctl request code */
|
|
|
-#define TTY_SPEK m2_l1 /* message parameter: ioctl speed, erasing */
|
|
|
-#define TTY_FLAGS m2_l2 /* message parameter: ioctl tty mode */
|
|
|
-#define TTY_PGRP m2_i3 /* message parameter: process group */
|
|
|
-
|
|
|
-/* Names of messages fields used in reply messages from tasks. */
|
|
|
-#define REP_PROC_NR m2_i1 /* # of proc on whose behalf I/O was done */
|
|
|
-#define REP_STATUS m2_i2 /* bytes transferred or error number */
|
|
|
-
|
|
|
-/* Names of fields for copy message to SYSTASK. */
|
|
|
-#define SRC_SPACE m5_c1 /* T or D space (stack is also D) */
|
|
|
-#define SRC_PROC_NR m5_i1 /* process to copy from */
|
|
|
-#define SRC_BUFFER m5_l1 /* virtual address where data come from */
|
|
|
-#define DST_SPACE m5_c2 /* T or D space (stack is also D) */
|
|
|
-#define DST_PROC_NR m5_i2 /* process to copy to */
|
|
|
-#define DST_BUFFER m5_l2 /* virtual address where data go to */
|
|
|
-#define COPY_BYTES m5_l3 /* number of bytes to copy */
|
|
|
-
|
|
|
-/* Field names for accounting, SYSTASK and miscellaneous. */
|
|
|
-#define USER_TIME m4_l1 /* user time consumed by process */
|
|
|
-#define SYSTEM_TIME m4_l2 /* system time consumed by process */
|
|
|
-#define CHILD_UTIME m4_l3 /* user time consumed by process' children */
|
|
|
-#define CHILD_STIME m4_l4 /* sys time consumed by process' children */
|
|
|
-
|
|
|
-#define PROC1 m1_i1 /* indicates a process */
|
|
|
-#define PROC2 m1_i2 /* indicates a process */
|
|
|
-#define PID m1_i3 /* process id passed from MM to kernel */
|
|
|
-#define STACK_PTR m1_p1 /* used for stack ptr in sys_exec, sys_getsp */
|
|
|
-#define PR m6_i1 /* process number for sys_sig */
|
|
|
-#define SIGNUM m6_i2 /* signal number for sys_sig */
|
|
|
-#define FUNC m6_f1 /* function pointer for sys_sig */
|
|
|
-#define MEM_PTR m1_p1 /* tells where memory map is for sys_newmap */
|
|
|
-#define CANCEL 0 /* general request to force a task to cancel */
|
|
|
-#define SIG_MAP m1_i2 /* used by kernel for passing signal bit map */
|
|
|
-
|
|
|
-#ifdef AMOEBA
|
|
|
-
|
|
|
-/* Names of message fields for amoeba tasks */
|
|
|
-#define AM_OP m2_i1 /* one of the above operators */
|
|
|
-#define AM_PROC_NR m2_i2 /* process # of proc doing operation */
|
|
|
-#define AM_COUNT m2_i3 /* size of buffer for operation */
|
|
|
-#define AM_ADDRESS m2_p1 /* address of buffer for operation */
|
|
|
-
|
|
|
-/* For communication between MM and AMOEBA_CLASS kernel tasks */
|
|
|
-#define AM_STATUS m2_i3 /* same use as REP_STATUS but for amoeba */
|
|
|
-#define AM_FREE_IT m2_l1 /* 1=not a getreq, 0=is a getreq */
|
|
|
-
|
|
|
-/* Special for passing a physical address from the ethernet driver */
|
|
|
-#define AM_PADDR m2_l1 /* to the transaction layer */
|
|
|
-
|
|
|
-#endif /* AMOEBA */
|
|
|
-
|
|
|
-#define HARD_INT 2 /* fcn code for all hardware interrupts */
|