123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263 |
- USA VERSION
- 01 32
- 02 33
- 03 34
- 04 35
- 05 [01] GND 36 [24] GND
- 06 [02] A11 37 [25] A12
- 07 [03] A10 38 [26] A13
- 08 [04] A9 39 [27] A14
- 09 [05] A8 40 [28] A15
- 10 [06] A7 41 [29] A16
- 11 [07] A6 42 [30] A17
- 12 [08] A5 43 [31] A18
- 13 [09] A4 44 [32] A19
- 14 [10] A3 45 [33] A20
- 15 [11] A2 46 [34] A21
- 16 [12] A1 47 [35] A22
- 17 [13] A0 48 [36] A23
- 18 [14] - 49 [37] U3-1 (LS139)
- 19 [15] D0 50 [38] D4
- 20 [16] D1 51 [39] D5
- 21 [17] D2 52 [40] D6
- 22 [18] D3 53 [41] D7
- 23 [19] /CHIP-ENABLE 54 [42] R/W (SAVE-RAM)
- 24 [20] CIC-1 (ID-OUT) 55 [43] CIC-2 (ID-OUT)
- 25 [21] CIC-7 (ID-IN) 56 [44] CIC-6 (ID-IN)
- 26 [22] U3-13 (LS139) 57 [45] -
- 27 [23] VCC 58 [46] VCC
- 28 59
- 29 60
- 30 61
- 31 62
- / = means low active
- .......................................SDI..................................
- Removal of USA/JAP/GER Protection
- The IC handling the Reset signal has 18 Pins (U8/F 411 Nintendo)
- You need to cut the original RESET (Pin 10) and wire it new to Pin 17.
- **********Wire****************************
- o /------\_/------\ *
- | |1 18|---+5V *
- | |2 17|**********(Valid Reset with Button
- | |3 16| from the SNES)
- | |4 15|
- \ |5 14|
- CUT |6 13|
- \ |7 12|
- | |8 11|
- | GND---|9 10|------o
- | \---------------/ |
- | |
- \-------------------------------------/
- Now you can sell your last module !!!!!! HEHEHEHE
- (This peace is designed on an USA SNES motherboard and i don`t know
- if this runs on JAP or GER SNES)
- .......................................SDI..................................
- �
|