Pārlūkot izejas kodu

mmc: fsl_esdhc_imx: check the clock stable status after config the clock rate.

Currently, after config the clock rate, delay 10ms, this is quite a rough
method. Check the clock stable status in the present status register is
enough.

Tested-by: Ji Luo <ji.luo@nxp.com>
Signed-off-by: Haibo Chen <haibo.chen@nxp.com>
Haibo Chen 3 gadi atpakaļ
vecāks
revīzija
f9c3a816c0
1 mainītis faili ar 6 papildinājumiem un 1 dzēšanām
  1. 6 1
      drivers/mmc/fsl_esdhc_imx.c

+ 6 - 1
drivers/mmc/fsl_esdhc_imx.c

@@ -36,6 +36,7 @@
 #include <dt-structs.h>
 #include <mapmem.h>
 #include <dm/ofnode.h>
+#include <linux/iopoll.h>
 
 #if !CONFIG_IS_ENABLED(BLK)
 #include "mmc_private.h"
@@ -631,6 +632,8 @@ static void set_sysctl(struct fsl_esdhc_priv *priv, struct mmc *mmc, uint clock)
 {
 	struct fsl_esdhc *regs = priv->esdhc_regs;
 	int div = 1;
+	u32 tmp;
+	int ret;
 #ifdef ARCH_MXC
 #ifdef CONFIG_MX53
 	/* For i.MX53 eSDHCv3, SYSCTL.SDCLKFS may not be set to 0. */
@@ -664,7 +667,9 @@ static void set_sysctl(struct fsl_esdhc_priv *priv, struct mmc *mmc, uint clock)
 
 	esdhc_clrsetbits32(&regs->sysctl, SYSCTL_CLOCK_MASK, clk);
 
-	udelay(10000);
+	ret = readx_poll_timeout(esdhc_read32, &regs->prsstat, tmp, tmp & PRSSTAT_SDSTB, 100);
+	if (ret)
+		pr_warn("fsl_esdhc_imx: Internal clock never stabilised.\n");
 
 #ifdef CONFIG_FSL_USDHC
 	esdhc_setbits32(&regs->vendorspec, VENDORSPEC_PEREN | VENDORSPEC_CKEN);