|
@@ -26,12 +26,10 @@
|
|
|
#define SPI_TX_BYTE BIT(8) /* transmit with 1 wire byte */
|
|
|
#define SPI_TX_DUAL BIT(9) /* transmit with 2 wires */
|
|
|
#define SPI_TX_QUAD BIT(10) /* transmit with 4 wires */
|
|
|
-
|
|
|
-/* SPI mode_rx flags */
|
|
|
-#define SPI_RX_SLOW BIT(0) /* receive with 1 wire slow */
|
|
|
-#define SPI_RX_FAST BIT(1) /* receive with 1 wire fast */
|
|
|
-#define SPI_RX_DUAL BIT(2) /* receive with 2 wires */
|
|
|
-#define SPI_RX_QUAD BIT(3) /* receive with 4 wires */
|
|
|
+#define SPI_RX_SLOW BIT(11) /* receive with 1 wire slow */
|
|
|
+#define SPI_RX_FAST BIT(12) /* receive with 1 wire fast */
|
|
|
+#define SPI_RX_DUAL BIT(13) /* receive with 2 wires */
|
|
|
+#define SPI_RX_QUAD BIT(14) /* receive with 4 wires */
|
|
|
|
|
|
/* SPI bus connection options - see enum spi_dual_flash */
|
|
|
#define SPI_CONN_DUAL_SHARED (1 << 0)
|
|
@@ -61,13 +59,11 @@ struct dm_spi_bus {
|
|
|
* @cs: Chip select number (0..n-1)
|
|
|
* @max_hz: Maximum bus speed that this slave can tolerate
|
|
|
* @mode: SPI mode to use for this device (see SPI mode flags)
|
|
|
- * @mode_rx: SPI RX mode to use for this slave (see SPI mode_rx flags)
|
|
|
*/
|
|
|
struct dm_spi_slave_platdata {
|
|
|
unsigned int cs;
|
|
|
uint max_hz;
|
|
|
uint mode;
|
|
|
- u8 mode_rx;
|
|
|
};
|
|
|
|
|
|
#endif /* CONFIG_DM_SPI */
|
|
@@ -94,7 +90,6 @@ struct dm_spi_slave_platdata {
|
|
|
* bus (bus->seq) so does not need to be stored
|
|
|
* @cs: ID of the chip select connected to the slave.
|
|
|
* @mode: SPI mode to use for this slave (see SPI mode flags)
|
|
|
- * @mode_rx: SPI RX mode to use for this slave (see SPI mode_rx flags)
|
|
|
* @wordlen: Size of SPI word in number of bits
|
|
|
* @max_write_size: If non-zero, the maximum number of bytes which can
|
|
|
* be written at once, excluding command bytes.
|
|
@@ -112,7 +107,6 @@ struct spi_slave {
|
|
|
unsigned int cs;
|
|
|
#endif
|
|
|
uint mode;
|
|
|
- u8 mode_rx;
|
|
|
unsigned int wordlen;
|
|
|
unsigned int max_write_size;
|
|
|
void *memory_map;
|