******************************** Xilinx ZCU106 board - ZynqMP SoC ******************************** This document describes the Buildroot support for the ZCU106 board by Xilinx, based on the Zynq UltraScale+ MPSoC (aka ZynqMP). It has been tested with the EK-U1-ZCU106-ES2 pre-production board. How to build it =============== Configure Buildroot: $ make zynqmp_zcu106_defconfig Compile everything and build the rootfs image: $ make Result of the build ------------------- After building, you should get a tree like this: output/images/ +-- atf-uboot.ub +-- bl31.bin +-- boot.bin +-- boot.vfat +-- Image +-- rootfs.ext2 +-- rootfs.ext4 -> rootfs.ext2 +-- sdcard.img +-- system.dtb -> zynqmp-zcu106-revA.dtb +-- u-boot.bin `-- zynqmp-zcu106-revA.dtb How to write the SD card ======================== WARNING! This will destroy all the card content. Use with care! The sdcard.img file is a complete bootable image ready to be written on the boot medium. To install it, simply copy the image to an SD card: # dd if=output/images/sdcard.img of=/dev/sdX Where 'sdX' is the device node of the SD. Eject the SD card, insert it in the board, and power it up.